Kenta gearmotor for pellet stoves (Cod: K9173007). Speed: 1 rpm, Shaft diameter: 9.5 mm (Rif.Int. 2059)

Description

Kenta gearmotor for pellet stoves (Cod: K9173007). Speed: 1 rpm, Shaft diameter: 9.5 mm (Rif.Int. 2059)

DESCRIPTION

Reference K9173007

Suitable for use in applications where low speed and high torque are required, the Kenta K9173007 gearmotor is specifically designed to be used as a rotor to power pellet stoves. 917 series, nominal torque 21Nm, absorption 26Watt, speed 1rpm, clockwise rotation, shaft diameter 9.5mm, 20mm reed valve pack, power supply 220 V AC – 50/60Hz.

INTERCHANGEABLE WITH THE FOLLOWING MODELS

MELLOR : FB1309, FB1178, FB1334, FB1330 MERKLE & KORFF : S10412

MOUNT ON STOVES

-ADLER
-ANSELMO COLA
-BRONPI
-CADEL
-MONTEGRAPPA FIREPLACES
-CLAM
-COLA
-DEVILLE
-ENVIRO FIRE
-GREEN PUROS
-KALOR
-NORDICA EXTRAFLAME
-MCZ
-OLIMPIA SPLENDID
-ARENAS
-PIAZZETTA
-PUROS
-ROYAL
-SIDEROS
-THERMOROSSI
-VULCANIA

USING THE GEAR MOTOR K9173007

The Kenta 1 rpm gear motor Code K9173007 proposed by Xodostore – Shaft ø 9.5 mm – 20 mm lamellar pack installed on pellet appliances has the task of rotating the auger in the pellet tank transporting it to the crucible to be burned, or the increasingly used automatic brazier cleaning systems present on many biomass stoves and boilers. The auger is positioned in such a way as to pick up the pellets from the bottom of the tank and then transport them to the top of the stove Once at the top of the auger, the pellets naturally fall into a chute that will accompany them inside the burner.

MAIN FEATURES OF KENTA GEARED MOTORS

The gearbox box is made of die-cast zamak and incorporates fixings
for the application. The kinematic chain of the gears consists of: helical tooth crankshaft, gears made of special thermoplastic materials and gears made of sintered steel. This system guarantees high reliability by allowing K911 gearmotors the possibility of applications in cold (e.g. chillers) and hot (e.g. ovens) environments. The gearbox housing has 2 through fixing holes and 5 fixing holes with a maximum penetration of 4 mm. The K911 AC gearmotors use two-pole single-phase asynchronous motors with short-circuit turns and
pre-set direction of rotation. The dimensions of the engines are fixed in terms of width and height (61 x 61
mm) while the thickness of the engine pack is available in 4 sizes: 16 – 20 – 30 – 40 mm. The winding of the coils is made by means of an automatic system equipped with wire-stabilized
tension control. The electrical connections are made by means of 6.3 x 0.8 fastons applied with a solderless insulation displacement system (UL approved Amtronics system) which prevents false contacts. Available voltages and frequencies: from 24 to 240 V and 50/60 Hz.
The K911 DC geared motors use brushed DC motors with permanent magnet
for 12 and 24 V power supply. These motors allow for dual rotation

FOLLOW US ON INSTAGRAM!